Leica iCON Training
iCON puts the model on the instrument and the as-built data back in the office, but only if the crew runs it the way it was meant to be run. We train your crew one-on-one, on your site, on the iCON robot, rover and controller you already own.
Request trainingWhat a session covers
Built around the work your crew does this month, not a syllabus.
Getting files onto the controller
Control points, linework and layout points in the right format, coordinate system and units, so the tablet loads fast and the first hour on site is not spent fixing files.
Setup and resection
Station setup, resections and backsights on an iCON robot, plus the checks that catch a bad setup in the first ten minutes.
Layout from the model
Staking points, lines and surfaces straight from the design in iCON Field, and recording what was actually built.
iCON GPS rovers
Rover setup, correction sources and site calibration, and knowing when GNSS is the wrong tool for the tolerance you are working to.
As-builts back to the office
Exporting as-built and check data in the formats the office and the design team can use without a translation step.
Something specific?
Tell us the instrument and what your crew keeps getting stuck on. That is what the session gets built around.
Request training →How it works
One-on-one, not a classroom
Personalized, so your crew grasps the technique on the work they actually do rather than on a demo site.
On your site, on your instrument
Using your control and your model. What is learned transfers, because nothing has to be translated afterward.
A named support team afterward
For the urgent request, the last minute question, and the thing that only comes up on week three.
Kept current
Firmware, software and method change. We keep clients current rather than leaving them on the version they were trained on.
Why this is the part people skip
iCON is approachable. Most crews are productive on an iCON robot inside a day, and that is exactly what makes training easy to skip.
What training changes is method: how to tie into control, how to check a setup, and what to do when the model and the slab disagree. That is where the difference between fast layout and rework lives, and it is not in the manual.
If your first project on the instrument matters, half a day is cheap insurance.
How to prepare project files for iCON →
We are an authorized Leica Geosystems Service and Distribution Partner. We sell, rent, service and train on everything we supply, from our own calibration center in Boise.
We travel to you
All 50 states. We can usually work around a live job rather than pulling a crew off one. Tell us the instrument, the crew size and where you are.
Request training Talk to our team →